According to a sketchy Russian site, perhaps flashing iLO firmware 1.77 in direct mode from the 8.50 Firmware CD can fix it.I don't currently have physical access to the server, but I will tomorrow, at which point I'll try the following: Reset NVRAM (and thus iLO) settings by removing the button battery in the server and then replacing it.Fiddled around with the iLO Security DIP switch, setting it both on and off.This worked, but it had to flash using direct mode, and even after doing another power cycle, the iLO remains unresponsive. I updated the iLO firmware to the latest version, v2.33, from CentOS 7 using the HP SPP ISO burnt onto a USB drive.I updated the BIOS to the latest version.In my case, I've unplugged the power cord and held down power for 30 seconds, but on the next boot, the iLO remains unresponsive. According to this site, power cycling and doing a full power flush usually fixes iLO not being responsive.(I upgraded it to 2.33, unsure if successful.) P410i integrated RAID card, LSI 9211-8i HBA card installed on latest (P20) IT firmware.

HP D元80 G6, on latest BIOS update, other firmware not updated.iLO does not show up on the network at all.Normally the POST screen is supposed to show something like 'Press F8 to Enter iLO Rom-Based Setup Utility', I think, but that does not appear, so I can't configure iLO.showing fans, RAM slots, CPUs) are all off except for the Ethernet 1 light (which is plugged in). The front-panel system health LEDs (e.g.

Booting into an HP SPP hangs after selecting Automatic/interactive modes, probably because it tries to detect the iLO and hangs.

On a CentOS 7 live USB, udev hangs while detecting devices, and dmesg shows that it tries to talk to the IPMI interface and times out.

System health monitoring has been disabled.

On POST, after the splash screen, it says Warning: iLO 2 not responding.

5) minutes, longer than would be expected. I recently purchased an HP D元80 G6 for homelab-esque usage, and I've found a few issues that I think are all caused by a nonresponsive iLO 2:

Ilo 2 latest firmware version